Building Regulation Studies2 Building Regulation Studies Question 5 The type of construction is determined by the Building Codes of Australia (BCA) building class and number of storeys of the building. In this scenario, the building is a two storey boarding house. The boarding house has a total floor area of 320 m2(exceeding 300 m2) and its top level has access to two external non fire isolated stairs. Therefore the classification of this building is class 3. According to Australian Building Codes Board (2019), the type of construction for a two storey class 3 building is type B. Question 6 The type of fire resisting construction is dependent on the type of construction. The building in this scenario has two storeys since the factory and office are not at the same level. One level of the building, which has a total floor area of 150m2, is an office building (class 5) and the other level, which has a total floor area of 600m2, is a factory (class 8). This implies that the top floor is smaller than the ground floor and located at one corner of the building, as illustrated by the schematic in Figure 1 below. Thus based on this combination (two storey and class 5 and 8 buildings), the type of construction for this building is type C(Queensland Building and Construction Commission, 2014).This means that the type of fire resting construction required for the building is type C (least fire resisting construction).
Building Regulation Studies3 Figure 1: Schematic of the building The fire resistance level (FRL) for the different building elements of type C fire resisting construction is provided in Table 1 below Table 1: FRL of type C fire resisting construction Building elementFire resistance level (FRL) Office (class 5)Factory (class 8) External wall90/90/9090/90/90 External column90/-/-90/-/- Common walls90/90/9090/90/90 Internal walls60/60/6060/60/60 Roofs-/-/--/-/- Question 12 The building in this scenario is a single storey factory (class 8), which is a type C that has a lower risk of fire thus it is the least fire resistant. Below are some of the requirements for the fire hydrant and fire hose reel of the building:
Building Regulation Studies4 ï‚·A fire hydrant system must be installed in each of the three sole occupancy units. This means that the building will have a total of three fire hydrant systems. This is because the building has three sole occupancy units each being a separate fire compartment. ï‚·The fire hydrant systems must be installed as per AS 2419.1 requirements so as to meet the applicable standards. ï‚·A fire hose reel must be installed near the exit of each of the three sole occupancy units. This means that the building will have a total of three fire hose reels so as to meet the required firefighting needs. ï‚·The fire hose reels can be installed externally, internally or in combination. ï‚·Each fire hose reel must be located adjoining to an internal fire hydrant or within 4 meters of an exit to make it easier to fight fire. ï‚·The fire hose reels should be clearly marked on a red sign with white letters and the signage located at least two meters above the floor and must be visible within two meters of the fire hose reel(Standards Australia, 2017).This will enable firefighters to identify them easily. ï‚·The height of the fire hose reels should be within the recommended limits of 1.4m to 2.4m(Integrated Fire Services, 2019)for easy reachability. ï‚·The fire hose reels must be installed as per AS 2441 requirements so as to meet the required performance standards. ï‚·Installation of fire hose reels must be such that the fire hose will not necessarily have to pass through entranceways that are fitted with smoke or fire doors to facilitate firefighting.
Paraphrase This Document
Need a fresh take? Get an instant paraphrase of this document with our AI Paraphraser
Building Regulation Studies5 ï‚·The fire hose reel should have a minimum length of 24 meters and a maximum length of 36 meters with a four meters spray from the nozzle. ï‚·The fire hydrant and fire hose reel valve should be easily reachable and not obstructed by items such as furniture. ï‚·The fire hose reels must be fixed strongly so as to ensure that the weight of the device is adequately supported and also the forces that the firefighting occupants will apply when pulling on the hose. ï‚·The design and location of the fire hose reel should facilitate easy unreeling. ï‚·If the desired pressure and flow cannot be achieved by the normal water supply then a water storage facility, pump or both must be installed to provide the minimum pressure and flow required. ï‚·There must be adequate water supply and storage for the fire hydrant systems and fire hose reels. Question 13 Some of the buildings that must have fire sprinkler protection are provided in Table 2 below Table 2: Types of buildings that must have fire sprinkler protection Type of buildingRational Buildings with at least four storeys or whose effective height is less than 25 meters (Australian Building Codes Board, 2019). These buildings pose a greater challenge for occupants to escape or firefighting team to fight the fire during fire outbreak. All classes of buildings that have more than three storeys, which includes all medium-rise residential buildings(Fire Protection Association Australia, 2018). They pose greater challenges for occupants to escape or firefighting team to fight the fire during fire outbreak. Class 9a and 9c buildings (healthcare buildings and residential aged care buildings)(Bicknell, 2019) These buildings accommodate people who are at a higher risk because of potential limitations (Fire Systems Australia SEQ, 2019). Class 6 buildings with a total floor area of moreThe buildings have a high risk of fire because of
Building Regulation Studies6 than 3,500 m2or total volume of more than 21,000 m3. the materials/substances and the large number of people they accommodate at any given time and activities therein. Class 7a and 7b buildings (including car park building with more than 40 vehicles and storage buildings such as warehouses). The buildings have a high risk of fire because of the materials/substances and activities therein. Apartments fitted out with flammable synthetic materials. Fire in these buildings spreads very quickly and can reach the deadly flashover stage in less than three minutes. Occupancies of excessive hazard with a total floor area of more than 2,000m2or volume of more than 12,000m3.(Australian Building Services, (n.d.)) These buildings have a high risk of fire because of the hazardous storage or processes. References
Building Regulation Studies7 Australian Building Codes Board, 2019.National Construction Code (NCC) 2019,Canberra: Australian Building Codes Board. Australian Building Services, (n.d.).Sprinklers.[Online] Available at:https://australianbuildingservices.wordpress.com/sprinklers/ [Accessed 11 December 2019]. Bicknell, T., 2019.New residential fire sprinkler requirements in NCC 2019.[Online] Available at:https://www.abcb.gov.au/Connect/Articles/2019/05/28/New-residential-fire-sprinkler- requirements-in-NCC-2019 [Accessed 11 December 2019]. Fire Protection Association Australia, 2018.New Sprinkler Rules Will Save Lives.[Online] Available at:http://www.fpaa.com.au/news/news/2018/12/new-sprinkler-rules-will-save-lives.aspx [Accessed 11 December 2019]. Fire Systems Australia SEQ, 2019.Sprinklers.[Online] Available at:http://fsaseq.com.au/products/major-products/sprinklers/ [Accessed 11 December 2019]. Integrated Fire Services, 2019.Determining the location of fire hose reels.[Online] Available at:https://integratedfire.com.au/blog/2018/7/12/determining-the-location-of-fire-hose-reels [Accessed 12 December 2019]. Queensland Building and Construction Commission, 2014.Building Codes of Australia (BCA) Classes of buildings.[Online] Available at:https://www.qbcc.qld.gov.au/building-codes-australia-bca-classes-buildings [Accessed 11 December 2019]. Standards Australia, 2017.AS 2419.1-2005 Fire hydrant installations – System design, installation and commissioning,Sydney: Standards Australia.