Setting up Actions on Windows System

This document provides step-by-step instructions on how to set up actions on a Windows system to restrict access to the local hard drive (C :) and its contents. It also includes instructions on setting up DHCP on Windows.

Computer Information System
1

Table of Contents
Question - 1................................................................................................................................3
Question - 2................................................................................................................................7
References................................................................................................................................13

Question - 1
In this task, we are need to setup the following two actions on the windows system such as,
don’t want that users to get access to the local hard drive (C :\) and also don’t want the
contents of the local hard drive. Set up the above actions by using the below steps.
First, in the Start Menu’s search box enter gpedit.msc and click on the Enter button. It is
illustrated below (Comer, 2015).

Next, navigate to select the user configuration  select Administrative Templates  click on
Windows Components  and press Windows Explorer option. Click on Setting and, double
click on, Prevent access to drive from My Computer. This step is illustrated below.
Then, select enable option and view the drop down menu which shows the below three
options such as,
 You can restrict certain drive.
 A combination of drives.

 Restrict them all.
The C:\ drive or any lettered drive where Windows is installed are the primary drives that are
probably wished to be restricted. Restriction to every single drive refers to denial of access to
the CD or the DVD drive. Moreover, using the flash drive is not possible if the user needs to
get the files from it. Here, we are choosing to restrict only the C drive, as illustrated below.

If the user opens My Computer, then he/she could see the listed drives, but when the user
tries to access the restricted drive, in such case the user will receive the below mentioned
error message.

Restricting the access to some specific drives is used for providing security and access the
measures. This process mainly helps to secure the shared computer.
Question - 2
Here, we are setting up DHCP on windows, by using the below steps.
First, the user is required to open the control panel as illustrated below (Hallberg, 2013).

Next, choose the network and sharing center as illustrated below.
Then, click on the wireless network connection as illustrated below.

Then, click on the internet protocol version 4 (TCP/ IPv4) as shown below.

Further, click on internet protocol version 4 properties as represented below.

Here, the default setting is obtained automatically by the IP address and automatically
provides the DNS server address option. But, we are selecting it using the following IP
address and the following DNS server addresses are selected. After, entering the IP address as
192.168.100.150, subnet mask as 255.255.255.0 and default gateway as 192.168.100.1. Enter
the preferred DNS server as 192.168.100.1 and alternative DNS server as 8.8.8.8. Finally,
click on OK button as represented below.

At last, check whether the DHCP worked successfully or not, by using the command prompt
to check the IP address. It shows that the user entered the IP as 192.168.100.150, subnet mask
as 255.255.255.0 and the default gateway as 192.168.100.1. This process is demonstrated
below.

Finally, DHCP server setting was completed successfully.
References
Comer, D. (2015). Computer Networks and Internets. Pearson Education Limited.
Hallberg, B. (2013). Networking. New York: McGraw-Hill Publishing.