Hydraulics and Pneumatics Lab - Unit 4 Lab Assignment 1

MET230L: Hydraulics and Pneumatics Lab
Unit 4 Lab Assignment 1
STATE CHANGES
EXERCISE 1
Figure 1: Circuit for exercise 1 before running the simulation
Figure 2: Circuit behavior when you press the run button

Figure 3: When momentarily switch button S1
Figure 4: K1 switch and 1M1 are actuated

Figure 5: 1V1 is actuated
Figure 6: Compressed air starts to rush to the cylinder S1 is released

Figure 7: Cylinder rod extends
Figure 8: Cylinder rod retracts after the electrical signal is cleared by releasing S1

EXERCISE 2
Figure 9: Built circuit for exercise 2
Figure 10: When S1 is pressed

Figure 11: K1 switch and 1M1 are actuated
Figure 12: 1V1 valve is actuated

Figure 13: S1 is released and air rushes to the cylinder.
Figure 14: Cylinder rod extends

Figure 15: Cylinder rod extends fully
Figure 16: Cylinder rod retracts