List of Figures
Figure 1.1 Illustration of the rolling
process.....................................................................................10
Figure 1.2 a) Flat rolling and b) Shape rolling (Behzadipour et al 2004)
..................................................................................................................
......................................10
Figure 1.3Schematic illustration of a) Longitudinal b) Cross and c) Skewed
rolling (Lange 1985)
...........................................................................................................................
..........................................11
Figure 1.4 Roll Mill Layout.............................
...................................................................................13
Fig 1.5: Typical cross sections in the roll bite. (a) round-oval pass, (b) oval-
square pass..............13
Fig 1.6: Comparison of predicted and measured rod
temperature.............................................................16
Fig 1.7: Comparison of predicted and measured loads, spindle
torque..........................................17
Fig 1.8: Structure of a cooling
nozzle.....................................................................................................19
Fig 1.9: Heat Transfer in a hot steel rod
mill.........................................................................................20
Fig 1.10: Transverse cross-section of a
workpiece................................................................................21

+13062052269

info@desklib.com

Investigating Technological Documentation at Industrial Rolling Workshop

Contribute Materials